pof file to his own board under Quartus II 11.0SP1 successfully,however, when he checked the Verify tab, it failed to download and reported that "verification failed for device number 1" ,how should I solve the problem?Ī: You can try the following approaches to solve this problem:ġ. sof file to the MAX 10 device first, then download the pof file into the device with the board keeping powering on.Ĩ. pof file to the MA10 device (for self-designed board), it failed and reported the following errors, why did this happen?Ī:It may be caused by the MAX10 device. And you can use either of the Quartus software version later than 10.1 to work with the Windows 10 64-bit.Ħ. Q: What is the operating temperature specification of the UBT?Ī:The UBT is designed to operate in the commercial temperature range (0 to 85C).ĥ.Q: Will USB-Blaster work under Windows 10 64-bit?Ī: Yes, the USB-Blaster work under Windows 10 64-bit. Please note that UBT can't detect the JTAG chain on the Intel Arria 10 GX FPGA Development Kit.Ĥ. Q: What is the difference between the UBT and Altera USB Blaster Download Cable (UBA)?Ī: The main difference is the JTAG circuit, Terasic UBT supports JTAG voltage 2.5v~3.3V, the Altera USB Blaster supports 1.8V~3.3V, they are compatible with other features. ![]() Q: What is the TCK Clock Frequency for UBT and AUB2 respectively?Ī: The USB Blaster Cable works with the Jtag clock 6M, while the USB Blaster II Cable works at 24M.ģ. The AUB2 (USB-Blaster II Download Cable) supports USB Blaster II circuit and JTAG Voltage: 5.0-V TTL, 3.3-V LVTTL/LVCMOS ,Single-ended I/O standards from 1.5 V to 3.3 V.Ĭustomers can refer to Intel Cyclone 10 LP device handbook: and check your board JTAG voltage to see which cable is compatible with their board.Ģ. Q:What is the difference between UBT and AUB2?Ī: The main difference is the JTAG circuit, the UBT(USB Blaster Download Cable) supports USB Blaster I circuit and JTAG Voltage: 2.5V ~ 3.3V. The Quartus version you installed: Q16.1 or others.ġ.Whether you tested follow the above processes.PC OS version: Win10-32bit or Win7-64bit or Linux-64bit.b.Test with another usb blaster cable.Ĭ.If still with the same problem, please contact our technical support team via and provide below information: ii.If step i is OK: a.Test with another PC to see if the OS can detect unknown device. I.Make sure the board power is on and the port on board which connected to PC is USB blaster port. If yes, please install the USB blaster driver refer to this link: Altera USB Blaster Driver Installation Instructions If Altera USB Blaster isn’t showed in Universal Serial Bus controllers, please check whether the Other devices has Unknown device.If yes, users can use Quartus programmer and download FPGA code. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |